8 Replies Latest reply: Aug 18, 2013 8:39 AM by bfan RSS

rc 71 remote

bfan

I purchased an extra rc71 remote so i could have 2 in one room to operate one of my genie clients, how do I pair it and will it affect the remote already paired?

  • Re: rc 71 remote
    peds48
    to pair it, 


    Press and hold MUTE and ENTER for a few seconds.  this will not affect the other paired remote

  • Re: rc 71 remote
    peds48

    so you want the same remote to control both the Genie and client?

  • Re: rc 71 remote
    peds48

    No sure what you are trying to do

  • Re: rc 71 remote
    peds48

    Un-Pairing

    RF4Ce/RF

    Mode

    This resets RF4CE pairing information

    and re-sets the remote to control of the

    receiver in IR mode. This does not clear

    the programmed devices if a TV ID has

    been programmed.

    Press MUTE + Select at the same time

    until the green LED blinks twice. Press

    9 8 7 on the remote, and the green LED

    should blink four times.

    Upon entry of an invalid key sequence, the

    remote LED will blink one long blink in

    red and return to normal operation.

    If the Genie Remote is in a programming

    state and has no input for 10 seconds, it

    will exit the programming state and return

    to the last pre-programmed code.

  • Re: rc 71 remote
    peds48

    RF Setup Client: Hold Mute and Enter

    HR44: Mute, Select, Ch Up, Enter

    • Re: rc 71 remote
      bfan

      do you have to use on screen program remote function before holding mute enter. there must be some way to select which client for remote to operate. some special reciever code you input? when you do the mue enter it flashes green for a while then ends red