Contributor
•
3 Messages
connecting a Uverse box to Panasonic TC-L37U3 TV
I just got a new 37 inch Panasonic Viera (TC-L37U3) and I am trying to connect it with an HDMI cable. When the HDMI cable is the only cable connected to the TV, I get no signal. The box is good, I had the ATT phone support check the box. The HD light comes on when the box is connected with the HDMI cable. I have follwed all of Panasonic's manaual and over the phone support to get the TV to get the signal, they are stumped I am too.Anybody have any experience with these TVs? Thanks.
Accepted Solution
Official Solution
aviewer
Expert
•
3.2K Messages
13 years ago
Did you use the input button to select HDMI1?
Check the viera button to be sure vierra link is off.
Make sure you are not in photo mode.
Can you get any over the air channels? When you press menu on the TV remote dose the menu display?
0
RCSMG
Expert
•
394 Messages
13 years ago
It could be that the hdmi cable is bad. I suggest you press the input button on the tv to make sure you have selected the correct hdmi input.
0
0
oz_1
Master
•
85 Messages
13 years ago
Do you have another HDMI cable you can use as an installer I have never run into a Panasonic Uverse issue with HDMI with the exception of a bad cable thats why we test
the cable prior to instalation. Also plug it in another HDMI port on the TV just to rule out a bad port and if all else fails use the cable to try a different device such as a Blu-Ray player or laptop with HDMI out.
0
0
aviewer
Expert
•
3.2K Messages
13 years ago
You could be on the wrong input, but the light should be out. Must be a bad cable.
How about changing the aspect in the STB to SD & back again.
How about disconnecting the HDMI, rebooting the STB and then connect the HDMI with the TV off then turn it on.
0
0
noodles0589
Contributor
•
3 Messages
13 years ago
I did reboot the box. I did go exchange the cable for new one. Same results.
I am connecting tot the HDMI 1 port on the TV and have tried every start up connection and port label Panasonic offers (Antenna, Cable, Not used, etc.) nothing has worked.
0
0
noodles0589
Contributor
•
3 Messages
13 years ago
THE VIERRA MODE!!!!! That did it!!! Thanks so much!!!!
0
0
aviewer
Expert
•
3.2K Messages
13 years ago
0
0
aviewer
Expert
•
3.2K Messages
13 years ago
Is the setting universal? Or, is it per input?
If universal, seems like a non-viera device should work set either way.
You say phone support could not help. Was that Panasonic support? If so maybe you should call them back & have them add the fix to their script.
0
0
ashtmck
Contributor
•
2 Messages
8 years ago
0
0
Wilber
Contributor
•
1 Message
8 years ago
I have a Panasonic HD Plasma purchased in 2007 TH-50PX75U
Had AT&T cable box installed within the last month.
When up use the remote the TV does not respond. You have to push the buttons repeatedly. It would appear the cable box is not responding to the remote however the light on the cable box is blinking every time the buttons are depressed. In addition: we tested hooking up another tv the remote and the box worked fine.
We had AT&T change the box and remote with no change. Just stated the problem was the TV and left.
0
0