New Member
•
1 Message
Help wiring splitters
In an effort to install a backboard and neaten up my comms room, I unhooked the 1x8 and the 1x4 splitter it was jumpered over to. Now I can’t get signal back. I have an hr-54 ,and an hr-22. The dish is 3d2lnbr0-02. Splitters had red pass thru power ports. The primary bedroom has the genie, basement has the hr22. I’ve toned out the wires and know which is which just can’t get either wired properly or settings in box properly. I’ve looked all over and don’t see a SWM with catv in and out.
shannon02
ACE - Expert
•
21.3K Messages
3 years ago
The coax from the HR54 has to connect to the red power pass through port on the SWM splitter connected to the dish. With only 2 receivers you only need the 4way splitter. There is no SWM splitter made with a catv in and out.
(edited)
0
0