HELP! How to reconnect my HR44-500 & Wireless Video Bridge

The port on the power inserter ‘OUT TO SWM’ goes into the wall or otherwise cabling going directly to the splitter/SWM LNB. The other port on the power inserter labeled ‘SIGNAL TO IRD’ goes to the Wireless Video Bridge port labeled ‘TO DISH’ OR something along the lines of that. Then, the port labeled ‘TO RECVR’ on the WVB goes to the HR44 SWM port.

Thank you so incredibly much for getting back to me.

Just to Recap...

Power to SWiM = Directly Into the wall 

Signal to IRD = To WVB (this has 2 insert Options - Towards LNB or SAT Rcvr)

HR 44 Rcvr - Either the "Towards LNB or SAT Rcvr" (one left over from option above) 

Does that sound about correct?

Also, there are only a few ports that go to the wall in my house. If I move the location, as long as they are correctly plugged in and the main receiver and WVB are next to each other should it work correctly or will I have to have it plugged in near the router. 

Yes, it sounds correct. WVB Sat RCVR port goes to HR44. 

As far as moving, NO. There is only one port on the SWM Splitter outside that delivers signal to your SWM LNB. If you move the power inserter to another room, error 775 will appear since the coax going into that room is not delivering any power to the LNB.

So, wherever the power inserter was originally, it MUST stay. If you decide to change it’s location, you need to go outside or wherever your SWM splitter is and CHANGE the cables around so that the room where the power inserter is plugged in is set to properly deliver power. It will need to be plugged into the POWER PASS port on the splitter.

I will give that a try, thanks so much! 

No problem. Hope it works for you fine.