Contributor
•
1 Message
Programming two RF remotes to run one receiver.
Hi,
We have a HD DVR (HR-21) set up in the basement living room. We use a video sender to send the signal to an upstairs room to occasionally watch stuff upstairs off the basement DVR.
I have a bunch of remotes, RF and IR, but can't figure out any way to "run" the downstairs DVR without running down there and getting the remote. 🙂
I have two RF remotes. How do you get them BOTH to run one DVR? I go through the normal setup, but it only works with the 1st one. Nothing happens with the 2nd.
Alternatively, if I could get one RF remote to run upstairs receiver primarily, and the downstairs DVR receiver on AV1 (with RF), that'd be good too. Again, I've tried to follow the given instructions to do this to no avail.
Are there alternate instructions out there? Or, is neither scenario possible?
thx!
We have a HD DVR (HR-21) set up in the basement living room. We use a video sender to send the signal to an upstairs room to occasionally watch stuff upstairs off the basement DVR.
I have a bunch of remotes, RF and IR, but can't figure out any way to "run" the downstairs DVR without running down there and getting the remote. 🙂
I have two RF remotes. How do you get them BOTH to run one DVR? I go through the normal setup, but it only works with the 1st one. Nothing happens with the 2nd.
Alternatively, if I could get one RF remote to run upstairs receiver primarily, and the downstairs DVR receiver on AV1 (with RF), that'd be good too. Again, I've tried to follow the given instructions to do this to no avail.
Are there alternate instructions out there? Or, is neither scenario possible?
thx!
No Responses!