how to reprogram S10-S2 to control volume on external audio amp

Hi @Gyrobob

We understand that your facing issues with connecting U-verse S10-S2 remote control with your Samsung TV and audio amp. We hear you, and are happy to assist you.

Refer to the below steps which helps you Program, troubleshoot, and find solutions for your U-verse TV S10 remote control.

Try this first if your remote is not working:

• Check the batteries if the appropriate button doesn't light up when pushed.
• Check all the cables to your device to make sure they are secure and connected properly.
• Unplug the receiver if you are still having trouble, and then wait two minutes before plugging it back in and turning it back on.

S10 remote control
For several years, this has been the standard remote control and is currently the most widely used. Visit our U-verse remotes at a glance article which gives detailed explanations of U-verse remote control buttons.

For more information please visit our article about https://www.att.com/support/article/u-verse-tv/KM1050738

Let us know how it goes.

For further assistance we're here to assist you.

Thank you for contacting AT&T Community & Forums!

Maria, AT&T Community Specialist.

Do I get control of the Yamaha audio amplifier/receiver by programming it as an AUX piece of equipment?

Is this the correct procedure to program the S10 so that it controls the volume on the Yamaha audio amp/receiver?

1. Power on the Yamaha audio amp/receiver.
2. Press and hold the mode AUX key along with the OK key. Hold both keys for one second, then release. The four mode keys on the Remote Control flash to indicate you are in the programming mode.
3. Enter 6007
4. The AUX key will give a long flash indicating it received the code.
5. Point the remote control at the audio receiver, and press the Power key to turn off the device and confirm programming.
   • If the device doesn't turn off, or not all functions work, then start again at step 1 with 6037 (or 6038, 6043, 6052, or 6053).
   • Press the Power key again to turn the device back on and check other functions.

Note: The selected mode key will flash eight times and the remote control will return to its normal operation if you do any of the following:

• Enter an invalid code.
• Press a key that is not a number key.
• Stay inactive for more than 20 seconds.

If this happens, the remote has left programming mode without saving any changes. You'll need to start over.