Contributor
•
2 Messages
No signal
Plugging in new tv to wireless receiver using HDMI cord. This receiver worked in my bedroom down the hall with a coax cable but does not on the new tv with HDMI. Says no signal. I have done hard reboot and still says no signal. Shows 4 or 5 green bars and shows it is linked with a green dot. Help!
Accepted Solution
Official Solution
JefferMC
ACE - Expert
•
36.9K Messages
9 years ago
Is the "No Signal" a message box (from the TV) with no other wording, or a full screen display showing possible solutions (from the U-verse TV Receiver)?
If the first one, you may need to change the inputs on your TV or check your cable. It the latter, follow the suggestions.
0
0
Stacyd71
Contributor
•
2 Messages
9 years ago
0
0
mibrnsurg
Expert
•
4.3K Messages
9 years ago
I'd do a whole house reboot.
Unplug the RG and DVR and STB(s)and any WAP for wireless receiver(s), wait 30 seconds and plug the RG back in.
When that turns all green, then plug the DVR back in and wait until it reboots. Then if there is a WAP, plug it in and let it turn green, it should be 3-6' from the RG.
Then plug in the STB(s), wait til it reboots and see if wireless TV works.
Acronym Guide so you understand all terms: http://www.dslreports.com/faq/17724
Good luck 😉
Chris
__________________________________________________________
Please NO SD stretch-o-vision or 480 SD HD Channels
Need Help? PM ATT Uverse Care (all service problems)
ATT Customer Care(billing and all other problems)
Your Results May Vary, In My Humble Opinion
I Call It Like I See It, Simply a U-verse user, nothing more
0
0