Contributor
•
2 Messages
Wireless receiver gets live TV but cannot see DVR
I have a wireless TV receivers. It works normally except it is unable to connect to the DVR receiver: when I try to pause, it says "Pause is not available. The DVR is currently unplugged or restarting". I can schedule a recording, however I cannot view the recordings or pause/rewind live TV. The default gateway reported in Network Settings indicates that the receiver may be connected to the wrong access point - it receives U-Verse from the generic WAP, an Linksys E1200 rather than from the U-Verse WAP. How do I get the receiver to connect to the U-Verse WAP?
Accepted Solution
Official Solution
aviewer
Expert
•
3.2K Messages
12 years ago
Disconnect power on RG, DVR and STBs. Remove wap.
Plug in RG wait for all green.
Plug in DVR wait for channel viewing.
plug wap into RG
Plug-in one STB then the other.
0
0
pikalax1
Contributor
•
2 Messages
12 years ago
- It is the standard Cisco ISB7005 with firmware 2.1.2512.52.
- The "Easy Remote" app works fine with the wired receivers but produces frequent errors with the ISB7005.
0
0
aviewer
Expert
•
3.2K Messages
12 years ago
If you are having problems - Try the remote in U-verse for iphone or - even better - Buddy TV.
Did you just mark this as a solution because you tried the multi-box reboot?
0
0
pruim4523
Contributor
•
1 Message
10 years ago
What do these abbreviations stand for?
0
0
skeeterintexas
ACE - Expert
•
28.3K Messages
10 years ago
RG - Residential Gateway. Same as a modem. Brains of the operation
WAP - Wireless Access Point
DVR - Digital Video Recorder. Records and stores programs.
STB - Set Top Box. Any additional boxes beyond the DVR.
0
0