Contributor
•
3 Messages
WPS button on Access Point
Hello. On 2 of my TV's I am getting a message to set up your wireless TV receiver (even though I've had UVerse for years). I am told to press and hold the WPS button on my Access Point for 10 seconds and then to press the ok button on the front of the TV Wireless Receiver. I followed the instructions but nothing seems to happen when I hold the WPS button for 10 seconds. I still pressed the OK button on the front of the TV w\Wireless Receiver but the TV eventually displays the Set up your Wireless TV Receiver instructions again. Please help.
Accepted Solution
Official Solution
_xyzzy_
Expert
•
3.6K Messages
5 years ago
Unplug the WAP and wireless receivers. Reboot the gateway (pull plug for 15 secs. and let it fully reboot) and after it's fully rebooted plug the WAP back in and then see if you can now peer the wireless receiver(s) to the WAP. If you still cannot peer with the WAP then I think the WAP failed somehow since it's hard to believe two wireless receivers both failed at the same time. If that's the case you will need to call tech support (800-288-2020) to see about getting a replacement WAP.
By the way, what did not work? This forum is for att uverse tv. Have no idea why ATTCares is referring you to an article on resetting a DirecTV receiver!
0
DIRECTVhelp
Community Support
•
254.4K Messages
5 years ago
Hello @kimmgonzalez,
I understand your issues in regards to your setting up your access point, so let's see what we can do to solve your issue.
You made need to reset the receiver, which you can learn how to do by following the guide on our website, and try to reconnect again after doing so.
Please let us know if you're able to connect after resetting your receiver.
Mihai AT&T Community Specialist
0
0
kimmgonzalez
Contributor
•
3 Messages
5 years ago
0
0
kimmgonzalez
Contributor
•
3 Messages
5 years ago
Thanks! That worked! I'm not sure why ATT cares was responding either. I appreciate the effort though.
0
0
Vivcru_4391
New Member
•
2 Messages
5 years ago
same thing happened to me, still no tv !
0
0
Vivcru_4391
New Member
•
2 Messages
5 years ago
what is WPS button on Access point?
0
0
Cfoste56
New Member
•
1 Message
4 years ago
should paired light be flashing red to green on WAP vap2500?
0
0
baseballisback
ACE - Professor
•
8.1K Messages
4 years ago
I believe they're both red. Is it not working? Unplug the receiver and WAP. Plug the WAP back in, then plug the receiver back in.
Let's keep this thread open for now, but in the future, please do not respond to threads older than a year.
0
0
Fred0068
1 Message
3 years ago
Where is the wps button on my router
0
0
gr8sho
ACE - Professor
•
1.5K Messages
3 years ago
@Fred0068
You can’t pair a Uverse TV settop box directly to the gateway or router, only the WAP (wireless access point).
0
0