
U-verse TV Equipment
How to install, troubleshoot & fix your equipment.
1.1K
All
Question
Change from att DVR model VIP 2262 to VIP 2250 and having problems
DVR model VIP 2262 was beginning to buzz loudly. Att sent a replacement model VIP 2250. After experiencing glitches, stops and starts, I did the reset after reset thing with no improvement. Called ATT and they sent another replacement only to have the same problem with the 2nd replacement. Now ATT w
Question
528
5
0
Error code 1
My U-Verse receiver looks like it is going through all the start-up processing and then shows a red X 1 error code. Doesn't do anything else. I've tried unplugging and re-booting the gateway, the modem and the receiver several times. Any ideas?
Question
833
3
0
Volume on the receiver got turned down by accident. I want to turn it back up, but don't know how
I replaced the batteries in my remote. When that happened, the remove stopped controlling the TV so I had to reset the remote. Between replacing the new batteries and getting it reset, the volume on the TV receiver got turned down. I need to know how to turn it backup. I cannot find any information
Question
92
1
0
Disable digital phone call notifications on U-verse tv screens?
How can I disable digital phone call notifications on U-verse tv screens?
Question
501
19
0
Accepted Solution
Official Solution
Caller ID on Uverse TV
How do you get the caller ID to display on a Uverse TV
Question
307
2
0
JBL sound bar
Just bought JBL sound bar that I would like to control with my Uverse S20 remote. I need the code but JBL is not on the list and I can't figure out how to actually contact a person at support.
Question
170
5
0
Accepted Solution
Official Solution
Red X
Main cable box shows a red ‘X’ in the middle of my tv screen secondary box works
Question
441
6
0
Accepted Solution
Official Solution
How do I connect the U-VERSE to HDMI 1 with ARC?
I have three HDMI connections in the back of my new TV, HMDI 1 has ARC in parentheses, HMDI 2 and HDMI 3 are both blank. Do I connect the U-VERSE to HDMI 1 with ARC in parentheses or either HDMI 2 or HDMI 3 which are both blank.
Question
280
1
0
Accepted Solution
Official Solution
What are some indications that a Uverse receiver is going bad?
After changing a channel, about 30 seconds later video/sound lock, goes to signal lost, then will come back in 2-5 minutes. EVERY time channel is changed. Can go to another channel right away, it is there, then locks, signal lost, will come back.
Question
1.5K
6
uverse to direct tv at at&t’s urgent request
Received MANY letters from at&t basically requiring a switch from UVerse to Direct TV streaming (fiber?). The correspondence warned that UVerse would no longer be viable. Switch completed today. Installer told me my DVR recordings and also the SCHEDULE of recordings would still be available, and tha
Question
815
4
0

